Morningstar TriStar TS-MPPT-45 45A Charge Controller power output problem

Take a look at the LED indicators and let us know what they say. Here's a guide: LED IndicationsValuable information can be provided by the three LED’s visible through the front cover.  Although there are many different LED indications, they have similar patterns to make it easier to interpret each LED display.  Consider as three groups of indications: General Transitions // Battery Status // Faults & Alarms.LED Display ExplanationG = green LED is litY / R = yellow LED is lit, then red LED is litG+Y = Green and Yellow are both lit at the same timeG+Y / R = Green & Yellow both lit, then Red is lit aloneSequencing LED patterns (faults) repeat until the fault is clearedGeneral Transitions• Controller start-up    G / Y / R  (one cycle)• Equalize request start    G+Y+R / G+Y+R / G / G• Equalize cancelled    G+Y+R / G+Y+R / R / R• Battery service is required*   all 3 LED’s blinking until service is reset*battery service notifi cation is only enabled in custom settingsBattery Status• General state-of-charge   see battery SOC indications below• Absorption state    G blinking (½ second on / ½ second off) • Equalization state    G fast blink (2 to 3 times per second)• Float state     G slow blink (1 second on / 1 second off)Faults & Alarms• Over-temperature    Y / R  sequencing• High voltage disconnect   G / R  sequencing• DIP switch fault     R / Y / G  sequencing• Self-test faults      R / Y / G  sequencing• Remote Temperature Sensor (RTS)  G+Y / Y+R  sequencing• Battery voltage sense    G+Y / Y+R  sequencing