I purchased two ET 185W solar panels a few weeks back and it did not include any instructions on how to properly wire the panels together or to another source. I am planning on using these panels to power a submersible pump and the panels will be be connected to a charge controller. I am just not that certain on how to physically wire the panels to the charge controller.
Can the wires be spliced together or does it require a special connector? Also, I was not certain on the proper grounding required for the panels in case of electrical shock. Any help would be greatly appreciated if there is certain literature or if there is an instruction guide on wiring panels that would be great. Thanks!
Comments
Thank you for the question Hunter. What kind of charge controller do you use?
Just to give you an idea, you can check Morningstar installation manual (pdf) here. Briefly, don't cut the connectors of the solar module because that would void the warranty. ET Solar has MC4 connectors. I suggest you buy two extension cables (one with female, one with male connector: the other side of the cables should be bare). You are going to connect the bare ends of the cables directly to the charge controller.
If you are using multiple solar panels, just connect them in series (+ to -), or in parallel (+ to +, - to -). There is going to one + and one - end of the array, which should be connected directly to the charge controller as explained above.
For the grounding, I'd suggest you read the Owner's manual of the charge controller. For the module grounding, all you need is a grounding lug for each module. You can refer to page 4 of ET Solar installation manual (pdf).
Thanks, this helps alot. I am using the Grundfos CU 200. I have the wiring diagram for the controller but it confused me becuase it says to ground the solar panels both in the ground and in the controller? Is there a way to spit the ground wires to accomplish this? Also, what is the normal distance the ground wire needs to be placed in the ground? Thanks
The solar module grounding is to be connected to the charge controller and then to the ground. is this how it looks inside?
yes, that is it, i'm just confused on how to ground both the solar panels to the ground and connect the same ground wire to the controller
You can start from the charge controller, go to solar panel and frame, then to grounding rod.
Check the attachments (pdf, and jpg):
Sounds like an excellent idea, especially when we think about gas prices.Electric vehicles are notoriously quiet. This isn't generally a selling point, but certainly a side benefit. Electric and hybrid cars are the target of some new legislation. The legislation would require these quiet vehicles to make more noise. Hybrid vehicles and electric automobiles could be made noisier with after-market parts. This equipment, however, may soon become mandatory. I found this here: Electric vehicles may be required to make gasoline-powered noise, cardealexpert.com/news-information